Scheduled presentations:

• Towards fitting material parameters of fibre-reinforced polymers through image analysis and micro-mechanical simulations
  *E. Rios (MTM, KU Leuven; CS, KU Leuven), C. Breite (MTM, KU Leuven), M. Mehdikhani (KU Leuven), M. Diehl (MTM, KU Leuven; CS, KU Leuven;), Y. Swolfs (MTM, KU Leuven)
• Adapting concrete experimental measurements in a FEM simulation for the development of a novel orthopaedic shoe.
  *J. Finder (Institute of Aircraft Design and Lightweight), H. Möllers (Institute of Polymer Materials and Plastics E), C. Schmidt (Institute of Production Engineering and Machi), S. Heimbs (Institute of Aircraft Design and Lightweight)
• Determination of a representative microstructure of a full composite pressure vessel using X-ray computed tomography
  *S. Upadhyay (KU Leuven), M. Mehdikhani (KU Leuven), S. V. Lomov (KU Leuven), D. Vandepitte (KU Leuven), Y. Swolfs (KU Leuven)
• Numerical and Experimental Study of a Butt-Joint Thermoplastic Composite Multi-Stringer Panel Under Compression
  *A. Pereira (Delft University of Technology), I. Lippers (Fokker/GKN Aerospace), J. Waleson (Fokker/GKN Aerospace), J. van Ingen (Fokker/GKN Aerospace), S. Turteltaub (Delft University of Technology), C. Bisagni (Delft University of Technology)
• Quantitative defects evaluation in composite materials by means of non-destructive Thermographic techniques supported by numerical simulations
  *S. Riaz (Politecnico Di Bari), G. Dell'Avvocato (Politecnico di Bari), D. Palumbo (Politecnico Di Bari), M. Cinefra (Politecnico di Bari), U. Galietti (Politecnico di Bari)
• Application of the Phase Field and Cohesive Zone Model to simulate the unfolding failure in curved composite laminates
  *S. Bushpalli (Fidamc), E. Graciani (Universidad de Seville), B. López-Romano (Fidamc)